8.16. Datalogic Magellan Scale Configuration
In this document, it will be explained how to configure Datalogic Magellan Scale on SambaPOS.
1. Installing Scale Module on Samba Market
You need to install Scale Module on Samba Market and restart the SambaPOS.
Main Menu > Samba Market > Click on Install button in Scale Module Part.
2. Adding Datalogic Scale as Device on SambaPOS
Go to Main Menu > Manage > Settings > Local Settings > Devices > Add Device > Select Datalogic Scale and click on Save.
After completing necessary editings, click on Save button.
3. Setting Up Datalogic Scale
3.1. Installing Datalogic Scale Driver
Download the setup file from here.
Extract the Opos folder and open the 610005425 folder and then right click on setup file and select Run as Administrator
3.2. Setting Up OPOS Properties Editor
You can find the OPOS Properties Editor file from below path;
C:\Program Files (x86)\DLSOPOS\OPE
3.2.0. COM Ports
If you know the COM port connection features of the devices, you can proceed to the below step and enter these features for the scanner and the scale.
If you don’t know, the safest thing is setting device COM Ports as )600 8 N 1 mode by using the Barcode and QR Codes which are found in the booklet.
To do this, read the barcodes and QR codes below in numerical order.
These barcodes permanently change your device’s Com port reading settings.
Enter Barcode;
9600 QR Code;
Exit Barcode;
Enter Barcode;
Scale Interface Settings;
Exit Barcode;
You can check this user manuel as reference.
3.2.1. Service Section
3.2.2. Scanners Section
MagellanSC Part;
COM Port: You need to select your COM Ports accordingly
Baud Rate: Must be 9600
Data Bits: Must be 8
Stop Bits: Must be One
Parity: Must be None
QS6000 and QSL Scanner Parts;
COM Port: You need to select your COM Ports accordingly
Baud Rate: Must be 9600
Data Bits: Must be 8
Stop Bits: Must be One
Parity: Must be None
RS232Imager and RS232Scanner Parts;
COM Port: You need to select your COM Ports accordingly
Baud Rate: Must be 9600
Data Bits: Must be 8
Stop Bits: Must be One
Parity: Must be None
After completing necessary editings, click on Apply button.
3.2.3. Scales Section
COM Port: You need to select your COM Ports accordingly
Baud Rate: Must be 9600
Data Bits: Must be 8
Stop Bits: Must be One
Parity: Must be None
RTS Control: Enabled
Units: Metric